Author Publications

1985

Kneijnsberg, H.P. and Verbraak, C.A. and Bouwhuis ten, M.J. (1985) Determination of texture distributions in inhomogeneously rolled Al single crystals using a topographical X-ray method. Acta Metallurgica, 33 (9). pp. 1759-1767. ISSN 0001-6160

Kneynsberg, H.P. and Verbraak, C.A. and Bouwhuis ten, M.J. (1985) The influence of inhomogeneous rolling on the capacity of aluminium anode foil material. Materials Science and Engineering, 72 (2). pp. 171-176. ISSN 0025-5416

1984

Heller, H.W.F. and Verbraak, C.A. and Kolster, B.H. (1984) Recrystallization at grain boundaries in deformed copper bicrystals. Acta Metallurgica, 32 (9). pp. 1395-1406. ISSN 0001-6160

1982

Willemse, P.F. and Naughton, B.P. and Verbraak, C.A. (1982) X-ray residual stress measurements on cold-drawn steel wire. Materials Science and Engineering, 56 (1). pp. 25-37. ISSN 0025-5416

1980

Bach, P.W. and Beyer, J. and Verbraak, C.A. (1980) Atom probe analysis of bainitic phase boundaries in a low alloyed Cr Mo steel. Scripta Metallurgica, 14 (2). pp. 205-210. ISSN 0036-9748

1978

Dapper, G. and Sloterdijk, W. and Verbraak, C.A. (1978) Removal of surface layers from plated materials: upgrading of scrap. Conservation & Recycling, 2 (2). pp. 117-121. ISSN 0361-3658

Hoekstra, S. and Lelie van der, H.M.M. and Verbraak, C.A. (1978) A general method of habit plane determination in bainitic steels — II. Habit plane determination of the bainite. Acta Metallurgica, 26 (10). pp. 1517-1527. ISSN 0001-6160

Hoekstra, S. and Ohm, R.K. and Verbraak, C.A. (1978) A general method of the habit plane determination in bainitic steels — I. Orientation determination of the austenite. Acta Metallurgica, 26 (10). pp. 1505-1516. ISSN 0001-6160

1974

Verbraak, C.A. and Slakhorst, J.W.H.G. (1974) The development of the texture of (112)[ 1] rolled Al, Cu and Ag. Scripta Metallurgica, 8 (3). pp. 217-221. ISSN 0036-9748