Validation of vibration testing for the assessment of the mechanical properties of human lumbar motion segments

Share/Save/Bookmark

Engelen, S.J.P.M. van and Ellenbroek, M.H.M. and Royen, B.J. van and Boer, A. de and Dieën, J.H. van (2012) Validation of vibration testing for the assessment of the mechanical properties of human lumbar motion segments. Journal of biomechanics, 45 (10). 1753 - 1758. ISSN 0021-9290

[img] PDF
Restricted to UT campus only
: Request a copy
476kB
Abstract:Experimental modal analysis is a non-destructive measurement technique, which applies low forces and small deformations to assess the integrity of a structure. It is therefore a promising method to study the mechanical properties of the spine in vivo. Previously, modal parameters successfully revealed artificially induced spinal injuries. The question remains however, whether experimental modal analysis can be applied successfully in human spinal segments with mechanical changes due to physiological processes. Since quasi-static mechanical testing is considered the “gold standard” for assessing intervertebral stiffness, the purpose of our study was to examine if the mechanical properties derived from vibration testing and quasi-static testing correlate.

Six cadaver human spines (L1–L5) were loaded quasi-statically in bending and torsion, while an optical system measured the angular rotations of the individual motion segments. Subsequently, the polysegmental spines were divided into L2–L3 and L4–L5 segments and a shaker was used to vibrate the upper vertebra, while its response was obtained from accelerometers in anteroposterior and mediolateral directions. From the resulting frequency response function the eigenfrequencies (ratio between stiffness and mass) and vibration modes (pattern of motion) were determined.

The vibration results showed clear eigenfrequencies for flexion–extension (mean 121.83 Hz, SD 40.05 Hz), lateroflexion (mean 132.17, SD 34.80 Hz) and axial rotation (mean 236.17 Hz, SD 81.45 Hz). Furthermore, the correlation between static and dynamic tests was significant (r=0.73, p=0.01). In conclusion, the findings from this study show that experimental modal analysis is a valid method to assess the mechanical properties of human lumbar motion segments
Item Type:Article
Copyright:© Elsevier
Faculty:
Engineering Technology (CTW)
Research Chair:
Research Group:
Link to this item:http://purl.utwente.nl/publications/81669
Official URL:http://dx.doi.org/10.1016/j.jbiomech.2012.05.009
Export this item as:BibTeX
EndNote
HTML Citation
Reference Manager

 

Repository Staff Only: item control page

Metis ID: 288259