SDI: Is it a reliable fouling index?

Share/Save/Bookmark

Al-Hadidi, A.M.M. and Kemperman, A.J.B. and Schippers, J.C. and Wessling, M. and Meer, W.G.J. van der (2012) SDI: Is it a reliable fouling index? Desalination and water treatment, 42 (1-3). 43 - 48. ISSN 1944-3994

[img] PDF
Restricted to UT campus only
: Request a copy
503kB
Abstract:The ASTM considers the silt density index (SDI) test as a standard test for fouling potential of RO and NF feed waters. Up to date, the SDI is used at many full- and pilot-scale installations. The design and choice of the applied RO pretreatment is to a large extent based on the SDI test on the raw feed water. Comparing and monitoring UF/MF membrane performance is another SDI application. From a practical point of view, the SDI of RO feed water preferably should be lower than 3. The SDI has several disadvantages making it an unreliable test. The SDI has a non linear relationship with the colloidal concentration in the water and it is not corrected for the feed water temperature. Besides that, the SDI is not based on any filtration model. SDI is trying to simulate the RO fouling using dead-end MF membrane. The modified fouling index (MFI) is another fouling index. The MFI is based on the cake filtration model, can be corrected for pressure and temperature and is therefore used as a promising alternative for the SDI. Nevertheless, the procedure of measuring a MFI is more difficult and not directly suitable for carrying out “in the field”. The objective of this study therefore is to determine a theoretical relationship between SDI and MFI, and to validate this with experimental results. This relationship can be used to investigate the influence of membrane and testing parameters on SDI under cake filtration conditions, implying this model is valid for cake filtration mechanism and a particle rejection of 100%. In order to calculate the SDI, the times t 1 and t 2 for collecting the first and second sample are predicted using the measured MFI value and the MFI definition. In this research, the influence of several parameters (such as temperature, membrane resistance, etc.) on the SDI will be shown. The experimental results show a good agreement with the theoretical work, but only if the cake filtration start builds up directly at the beginning of the experiment. In general, this work clearly demonstrates that SDI currently is not reliable test for RO fouling. Either corrections for the SDI are necessary to give a more reliable index, or a new index has to be developed.
Item Type:Article
Copyright:© 2012 Taylor & Francis
Faculty:
Science and Technology (TNW)
Research Group:
Link to this item:http://purl.utwente.nl/publications/80097
Official URL:http://dx.doi.org/10.1080/19443994.2012.683102
Export this item as:BibTeX
EndNote
HTML Citation
Reference Manager

 

Repository Staff Only: item control page

Metis ID: 291570