Determination of flow curves under equibiaxial stress conditions

Share/Save/Bookmark

Mulder, J. and Vegter, H. and Ha, J.J. and Boogaard, A.H. van den (2012) Determination of flow curves under equibiaxial stress conditions. Key engineering materials, 504-506 . 53 - 58. ISSN 1013-9826

[img] PDF
Restricted to UT campus only
: Request a copy
337kB
Abstract:Three experimental methods have been used to establish flow curves for a low carbon steel under biaxial stress conditions: the hydraulic bulge test, the stack compression test and the biaxial tensile test. The individual tests are discussed and the results for a DC06 IF steel grade compared. Initially the results appear to be different but after compensation for strain rate and temperature the static hardening curves are coinciding.
Item Type:Article
Copyright:© 2012 Trans Tech Publications
Faculty:
Engineering Technology (CTW)
Research Chair:
Research Group:
Link to this item:http://purl.utwente.nl/publications/80047
Official URL:http://dx.doi.org/10.4028/www.scientific.net/KEM.504-506.53
Export this item as:BibTeX
EndNote
HTML Citation
Reference Manager

 

Repository Staff Only: item control page

Metis ID: 285671