Single asperity abrasion of coated nodular cast iron

Share/Save/Bookmark

Masen, M.A. and Rooij, M.B. de and Schipper, D.J. and Adachi, K. and Kato, K. (2007) Single asperity abrasion of coated nodular cast iron. Tribology International, 40 (2). pp. 170-179. ISSN 0301-679X

[img] PDF
Restricted to UT campus only
: Request a copy
701kB
Abstract:In the sliding contact between a rigid indenter and a softer deforming surface, a wear scar is formed in the softer surface. This wear scar consists of a groove flanked by two shoulders, where part of the material from the groove is transferred to these shoulders and the rest is actually removed from the surface as wear debris. The proportion of actually removed material is characterised by the degree of wear parameter ξ. This paper focusses on the experimental determination of the degree of wear for nodular cast iron with a range of hard surface layers. This is done using a pin-on-disk set-up that is located in the chamber of a scanning electron microscope. From these experimental results, an empirical model that describes the volumetric abrasive wear of coated nodular cast iron in single indenter scratching is developed.
Item Type:Article
Copyright:© 2007 Elsevier
Faculty:
Engineering Technology (CTW)
Research Chair:
Research Group:
Link to this item:http://purl.utwente.nl/publications/78625
Official URL:http://dx.doi.org/10.1016/j.triboint.2005.11.023
Export this item as:BibTeX
EndNote
HTML Citation
Reference Manager

 

Repository Staff Only: item control page

Metis ID: 235871