Process modelling for air bending: validation by experiments and simulations

Share/Save/Bookmark

Streppel, A.H. and Lutters, D. and Brinke, E. ten and Pijlman, H.H. and Kals, H.J.J. (2001) Process modelling for air bending: validation by experiments and simulations. Journal of Materials Processing Technology, 115 (1). pp. 76-82. ISSN 0924-0136

[img] PDF
Restricted to UT campus only
: Request a copy
471kB
Abstract:In order to evaluate and justify the use of bending simulations in e.g. CAPP applications, the simulations have to be compared to realistic samples from shop floor practice. However, input data concerning e.g. material behaviour, sheet thickness and tool geometry can be controlled in an adequate, reproducible way if obtained under laboratory conditions.

The bending setup leading to the experimental data is elaborated upon. The experiments mainly address the required punch displacement and the sheet length correction, being the main concerns in CAPP applications.

The experiments are employed to evaluate results of simulations of the air bending process. In this case, the results of the equilibrium model, called the ABS model (air bending simulation) and a finite element method analysis (FEM) (both described in an accompanying publication), are involved in the experimental verification.

Diverging trends in the analysis can indicate deficits in the simulations. Presumably, these aberrations can be reflected on the differing assumptions and principles applied in the models or assumptions concerning material behaviour.
Item Type:Article
Copyright:© 1968 Elsevier
Faculty:
Engineering Technology (CTW)
Research Group:
Link to this item:http://purl.utwente.nl/publications/74520
Official URL:http://dx.doi.org/10.1016/S0924-0136(01)00772-5
Export this item as:BibTeX
EndNote
HTML Citation
Reference Manager

 

Repository Staff Only: item control page

Metis ID: 204266