Design and fabrication of a planar three-DOFs MEMS-based manipulator


Jong, Boudewijn R. de and Brouwer, Dannis M. and Boer, Meint J. de and Jansen, Henri V. and Soemers, Herman M.J.R. and Krijnen, Gijs J.M. (2010) Design and fabrication of a planar three-DOFs MEMS-based manipulator. Journal of microelectromechanical systems, 19 (5). pp. 1116-1130. ISSN 1057-7157

open access
Abstract:This paper presents the design, modeling, and fabrication of a planar three-degrees-of-freedom parallel kinematic manipulator, fabricated with a simple two-mask process in conventional highly doped single-crystalline silicon (SCS) wafers (100). The manipulator’s purpose is to provide accurate and stable positioning of a small sample (10 × 20 × 0.2 μm3), e.g., within a transmission electron microscope. The manipulator design is based on the principles of exact constraint design, resulting in a high actuation-compliance combined with a relatively high suspension stiffness. A modal analysis shows that the fourth vibration mode frequency is at least a factor 11 higher than the first three actuation-related mode frequencies. The comb-drive actuators are modeled in combination with the shuttle suspensions gaining insight into the side and rotational pull-in stability conditions. The two-mask fabrication process enables high-aspect-ratio structures, combined with electrical trench insulation. Trench insulation allows structures in conventional wafers to be mechanically connected while being electrically insulated from each other. Device characterization shows high linearity of displacement wrt voltage squared over ±10 μm stroke in the x- and y-directions and ±2◦ rotation at a maximum of 50 V driving voltage. Out-of-plane displacement crosstalk due to in-plane actuation in resonance is measured to be less than 20 pm. The hysteresis in SCS, measured using white light interferometry, is shown to be extremely small.
Item Type:Article
Copyright:© 2010 IEEE
Engineering Technology (CTW)
Electrical Engineering, Mathematics and Computer Science (EEMCS)
Research Group:
Link to this item:
Official URL:
Export this item as:BibTeX
HTML Citation
Reference Manager


Repository Staff Only: item control page

Metis ID: 267195