Tolerancing and Sheet Bending in Small Batch Part Manufacturing

Share/Save/Bookmark

Vin, L.J. de and Streppel, A.H. and Kals, H.J.J. (1994) Tolerancing and Sheet Bending in Small Batch Part Manufacturing. CIRP Annals, 43 (1). pp. 421-424. ISSN 0007-8506

open access
[img] PDF
554kB
Abstract:Tolerances indicate geometrical limits between which a component is expected to perform its function adequately. They are used for instance for set-up selection in process planning and for inspection. Tolerances must be accounted for in sequencing and positioning procedures for bending of sheet metal parts. In bending, the shape of a part changes not only locally, but globally as well. Therefore, sheet metal part manufacturing presents some specific problems as regards reasoning about tolerances. The paper focuses on the interpretation and conversion of tolerances as part of a sequencing procedure for bending to be used in an integrated CAPP system.
Item Type:Article
Copyright:© 1994 Elsevier
Research Group:
Link to this item:http://purl.utwente.nl/publications/73192
Official URL:http://dx.doi.org/10.1016/S0007-8506(07)62244-6
Export this item as:BibTeX
EndNote
HTML Citation
Reference Manager

 

Repository Staff Only: item control page

Metis ID: 144634