Criterion for surface contact deformation of metals

Share/Save/Bookmark

Jamari, J. and Schipper, D.J. (2007) Criterion for surface contact deformation of metals. Tribotest, 13 (1). pp. 1-11. ISSN 1354-4063

[img]PDF
Restricted to UT campus only
: Request a copy
571Kb
Abstract:In most engineering applications, bulk plastic deformation of the surface is avoided. There is, however, no criterion for determining whether or not bulk plastic deformation occurs during the contact between rough surfaces. This paper presents a criterion for predicting the deformation behaviour of the contact between a real rough surface against a curved body. In order to verify the proposed criterion, experimental investigations were carried out for three different materials. It was found that the experimental results confirmed the proposed criterion very well. For a given operational contact condition, a contact system where bulk deformation does not occur can be designed using this criterion. If the criterion value Cm is less than 0.52 plastic deformation occurs on asperity level only and there is no bulk deformation, but if Cm is greater than 0.52 there are two possible deformation modes, i.e. plastic deformation of the bulk and plastic deformation in both the asperity and the bulk.
Item Type:Article
Copyright:© 2007 Wiley InterScience
Faculty:
Engineering Technology (CTW)
Research Group:
Link to this item:http://purl.utwente.nl/publications/72331
Official URL:http://dx.doi.org/10.1002/tt.28
Export this item as:BibTeX
EndNote
HTML Citation
Reference Manager

 

Repository Staff Only: item control page

Metis ID: 245600