The influence of curvature on FLC’s of mild steel, (A)HSS and aluminium


Share/Save/Bookmark

Atzema, E.H. and Fictorie, E. and Boogaard van den, A.H. and Droog, J.M.M. (2010) The influence of curvature on FLC’s of mild steel, (A)HSS and aluminium. In: IDDRG 2010 International Conference, May 31 - June 2, 2010, Graz, Austria.

[img]PDF
216Kb
Abstract:In literature the influence of curvature on formability has been reported. This
paper shows results for four materials when an FLC is measured with increasing curvature. It shows the FLC increases for sharper curvature most notably with 20 [mm] tool diameter. The increase is negligible on the left hand side, moderate on the right hand side and large on the plane strain axis. It is thought that contact pressure plays a role here and preliminary simulations indicate that this is quite possible.
Item Type:Conference or Workshop Item
Faculty:
Engineering Technology (CTW)
Research Chair:
Research Group:
Link to this item:http://purl.utwente.nl/publications/71874
Export this item as:BibTeX
EndNote
HTML Citation
Reference Manager

 

Repository Staff Only: item control page

Metis ID: 266996