Dry-sliding self-lubricating ceramics: CuO doped 3Y-TZP

Share/Save/Bookmark

Ran, Shen and Winnubst, Louis and Blank, Dave H.A. and Pasaribu, Henry R. and Sloetjes, Jan-Willem and Schipper, Dik J. (2009) Dry-sliding self-lubricating ceramics: CuO doped 3Y-TZP. Wear, 267 (9-10). pp. 1696-1701. ISSN 0043-1648

[img]PDF
Restricted to UT campus only
: Request a copy
1153Kb
Abstract:Dense 8 mol% CuO doped 3Y-TZP ceramics prepared by pressureless sintering at 1500 °C exhibits a good wear-resistance (specific wear rate k < 10−6 mm3 N−1 m−1) and promisingly low friction (coefficient of friction f = 0.2–0.3) when sliding against an alumina ball under unlubricated conditions. It was recognized that a self-lubricating mechanism is the most important contribution to the reduction of friction. During operation of the tribosystem, a soft interfacial patchy layer is generated in the contact area. As confirmed by calculations, based on a deterministic friction model, this soft interfacial patchy layer reduces friction. It was demonstrated that the presence of copper oxide is important for the formation of such an interfacial layer. The mechanism of the transition from mild to severe wear was also investigated. Detachment of a top layer in the wear track was proven to be the main reason for this tribological change.
Item Type:Article
Copyright:Elsevier
Faculty:
Science and Technology (TNW)
Engineering Technology (CTW)
Research Group:
Link to this item:http://purl.utwente.nl/publications/71863
Official URL:http://dx.doi.org/10.1016/j.wear.2009.06.033
Export this item as:BibTeX
EndNote
HTML Citation
Reference Manager

 

Repository Staff Only: item control page

Metis ID: 258169