A novel method for the fabrication of freestanding PZT features on substrates

Share/Save/Bookmark

Bennekom van, Joost G. and Winnubst, Louis and Nijdam, Wietze and Wessling, Matthias and Lammertink, Rob G.H. (2009) A novel method for the fabrication of freestanding PZT features on substrates. Journal of the European Ceramic Society, 29 (15). pp. 3227-3233. ISSN 0955-2219

[img]PDF
Restricted to UT campus only
: Request a copy
1238Kb
Abstract:A simple and cheap micromoulding fabrication route was developed to prepare freestanding piezo active features. Dimensions as small as 200 μm by 200 μm and 40 μm high were successfully fabricated via a replication technique. The lead zirconate titanate features were thoroughly characterized using SEM, EDX and XRD analysis. The properties of the features were influenced by several factors like the type of substrate, sintering temperature and sintering atmosphere. Features prepared on alumina substrates and sintered in lead atmosphere displayed a structure with reproducible dimensions. Next to that they were low in porosity and had a comparable composition with respect to the starting powder. The remanent polarization of the lead zirconate film was 12.3 μC/cm2 and the coercive field was 8.7 kV/cm.
Item Type:Article
Copyright:Elsevier Ltd
Faculty:
Science and Technology (TNW)
Research Group:
Link to this item:http://purl.utwente.nl/publications/71505
Official URL:http://dx.doi.org/10.1016/j.jeurceramsoc.2009.06.019
Export this item as:BibTeX
EndNote
HTML Citation
Reference Manager

 

Repository Staff Only: item control page

Metis ID: 258209