Stabilization of supported liquid membranes by gelation with PVC

Share/Save/Bookmark

Kemperman, A.J.B. and Damink, B. and Boomgaard van den, Th. and Strathmann, H. (1997) Stabilization of supported liquid membranes by gelation with PVC. Journal of Applied Polymer Science, 65 (6). pp. 1205-1216. ISSN 0021-8995

[img]
Preview
PDF
173Kb
Abstract:This article describes the gelation by PVC of supported liquid membranes (SLMs) for nitrate removal using a quaternary ammonium salt as carrier. Untreated SLMs with this carrier are very unstable. To improve their stability, the LM-phase was gelled with polyvinyl chloride as gel-forming polymer. Both homogeneous gelations of the LM-phase as well as the application of an interfacial gel layer are described. In all cases, no improvement of the stability could be observed. For both types of gelation, the initial nitrate flux decreased while the flux after 1 day of degradation was almost zero. The flux decrease is the result of a decrease of the diffusion rate of carrier complex as a result of the presence of the gel network and the thickness of the applied gel layer. The absence of any stability improvement might indicate that the loss of LM-phase from these membranes is due to dissolution of carrier or membrane solvent and not a result of emulsion formation only.
Item Type:Article
Copyright:© 1997 Wiley InterScience
Faculty:
Science and Technology (TNW)
Research Group:
Link to this item:http://purl.utwente.nl/publications/71425
Official URL:http://www3.interscience.wiley.com/journal/43572/abstract
Export this item as:BibTeX
EndNote
HTML Citation
Reference Manager

 

Repository Staff Only: item control page

Metis ID: 106186