Morphology of extruded high-density polyethylene pipes studied by atomic force microscopy

Share/Save/Bookmark

Trifonova, Dorina and Drouillon, Philippe and Ghanem, Antoine and Vancso, G. Julius (1997) Morphology of extruded high-density polyethylene pipes studied by atomic force microscopy. Journal of Applied Polymer Science, 66 (3). pp. 515-523. ISSN 0021-8995

[img]
Preview
PDF
634Kb
Abstract:Atomic force microscopy (AFM) was used to study the structure of extruded polyethylene (PE) pipe. During extrusion, the outer surface of the pipe was cooled with water. Two cross sections, parallel and transverse to the extrusion direction, were examined in order to spatially follow the structural development during extrusion. The morphology revealed was spherulitic, and the spherulites had a mostly banded appearance when viewed under the AFM. We were not able to distinguish an oriented skin layer at the surface of the pipe, either by AFM or polarizing microscopy. The changes in the pipe's structure resulting from the cooling conditions were found to be rather gradual, and no clearly defined zones were observed. A slight orientation towards the extrusion direction was detected only in the area of the pipe crystallized under the lowest degree of undercooling. Measured spherulitic size, band period, and lamellae thickness showed a gradual increase in their values from the cooled to the noncooled surface of the pipe. Transmission electron microscopy (TEM) was used to verify the band period and lamellae thickness measurements done by AFM.
Item Type:Article
Copyright:© 1997 Wiley InterScience
Faculty:
Science and Technology (TNW)
Research Group:
Link to this item:http://purl.utwente.nl/publications/71422
Official URL:http://www3.interscience.wiley.com/journal/43777/abstract
Export this item as:BibTeX
EndNote
HTML Citation
Reference Manager

 

Repository Staff Only: item control page

Metis ID: 105735