Strategy in Generative Planning of Turning Processes

Share/Save/Bookmark

Houten van, F.J.A.M. and Kals, H.J.J. (1986) Strategy in Generative Planning of Turning Processes. CIRP Annals, 35 (1). pp. 331-335. ISSN 0007-8506

[img]
Preview
PDF
523Kb
Abstract:This paper reports on the process and operations planning system ROUND and the strategies which underlie the decision making processes in the planning of turning operations. At first, an outline is given about the environment for which generative systems like ROUND are being developed. The differences between high volume production and job shop production, with respect to flexibility and productivity, are designated. The impact of automation on job shop production and its consequences for process and operations planning are discussed. In small batch manufacturing systems, relatively large amounts of process planning data have to be processed, which leads to an increasing interest for sophisticated computer aided process planning tools. Because available NC part programming systems usually do not support the generation of reliable and economic technological data, it is necessary to develop generative process and operation planning systems. Due to the relative complexity of the technological models, generative systems use a lot of computing power. Reduction of possible variants, combined with model refinement are techniques which are used in ROUND, in order to avoid excessive iteration. This is illustrated by the explanation of strategies which are implemented in two newly developed modules: The clamping module RNDFIX and the module for selection of tools for the roughing operation RNDRTL.
Item Type:Article
Copyright:© 1986 Elsevier Science
Faculty:
Engineering Technology (CTW)
Research Group:
Link to this item:http://purl.utwente.nl/publications/69592
Official URL:http://dx.doi.org/10.1016/S0007-8506(07)61900-3
Export this item as:BibTeX
EndNote
HTML Citation
Reference Manager

 

Repository Staff Only: item control page