Modelling of a burr-free blanking process

Wisselink, H.H. and Klaseboer, G. and Huetink, H. (2009) Modelling of a burr-free blanking process. International journal of material forming, 2 (Suppl.). pp. 539-542. ISSN 1960-6206

PDF
Restricted to UT campus only: Request a copy
2441Kb

Abstract:	A two step burr-free blanking process is investigated, where the deformation due to the preceding deepdrawing process is taken into account. FEM simulations have been carried out using a nonlocal damage model to obtain mesh independent results. It is shown how the parameters of the damage model influence the failure in the blanking process. Furthermore the simulations are validated with the measured contour and hardness of the part in different stages of the process.
Item Type:	Article
Copyright:	(c) UT Universiteit Twente, 2009
Faculty:	Engineering Technology (CTW)
Research Chair:	Mechanics of Forming Technology (MFT)
Research Group:	Applied Mechanics (AM)
Link to this item:	http://purl.utwente.nl/publications/69235
Official URL:	http://dx.doi.org/10.1007/s12289-009-0490-0
Export this item as:	BibTeX EndNote HTML Citation Reference Manager

Show download statistics for this publication

Repository Staff Only: item control page

Metis ID: 261285