The polymerization of propadiene by Ni(acac)2, C3H4, RnAlX3−n catalysts

Share/Save/Bookmark

Ommen, J.G. van and Berkel, P.C.J.M. van and Gellings, P.J. (1980) The polymerization of propadiene by Ni(acac)2, C3H4, RnAlX3−n catalysts. European Polymer Journal, 16 (8). pp. 745-752. ISSN 0014-3057

open access
[img]
Preview
PDF
565kB
Abstract:Catalyst formation in the system Ni(acac)2, C3H4, RnAlX3−n was studied. Polymerization experiments showed that, by replacing ionic groups such as acac−, Br−, Cl− with alkyl or hydride groups, an active catalyst is obtained. Electrolysis of Ni(acac)2 in tetrahydrofuran also gives an active catalyst. Lewis acids like (iBu)3Al and Et3Al increase the polymerization rate, while Lewis bases like pyridine and triphenylphosphine not only decrease the rate but also change selectivity. The selectivity is not changed if different transition metals (e.g. Co, Pd, Ni) are used. Kinetic measurements show a first order dependence on Ni. The dependence on (iBu)3Al changes from first to zero order with increasing Al/Ni ratio. This can be explained by assuming that the very active catalyst is formed via an equilibrium between a nickel complex and (iBu)3Al. A first order deactivation of the nickel catalyst is observed; it is faster during polymerization than during ageing of the catalyst.
Item Type:Article
Copyright:© 1980 Elsevier Science
Link to this item:http://purl.utwente.nl/publications/68484
Official URL:http://dx.doi.org/10.1016/0014-3057(80)90043-9
Export this item as:BibTeX
EndNote
HTML Citation
Reference Manager

 

Repository Staff Only: item control page