Copper chemical mechanical polishing using a slurry-free technique

Share/Save/Bookmark

Nguyen, V.H. and Hof, A.J. and Kranenburg van, H. and Woerlee, P.H. and Weimar, F. (2001) Copper chemical mechanical polishing using a slurry-free technique. Microelectronic Engineering, 55 (1-4). pp. 305-312. ISSN 0167-9317

[img]PDF
Restricted to UT campus only
: Request a copy
755Kb
Abstract:A study of the chemical mechanical polishing (CMP) of thin copper films using fixed-abrasive pads is presented. The composition of the polishing solution is optimized by investigating the impact of both the oxidizer concentration and the pH of the solution on the polishing characteristics of copper. The resulting optimum polishing solution gives a high removal rate (>300 nm/min), good uniformity (standard deviation 3%) and a very high selectivity for the oxide removal rate (>100:1). The dependence of the removal rate of copper on the geometry is studied for different feature sizes and various pattern densities. The geometry dependency is considerably less in the slurry-free process than in the conventional slurry CMP. This is crucial for copper CMP because it helps to minimize the overpolishing time and consequently the amount of dishing. Damascene copper structures have been successfully made by polishing patterned test wafers. The amount of dishing of the copper lines is smaller than that for the conventional polishing technique. The polished wafers were easily cleaned; a standard rinsing step seemed to be sufficient.
Item Type:Article
Copyright:© 2001 Elsevier
Faculty:
Electrical Engineering, Mathematics and Computer Science (EEMCS)
Research Group:
Link to this item:http://purl.utwente.nl/publications/67778
Official URL:http://dx.doi.org/10.1016/S0167-9317(00)00461-5
Export this item as:BibTeX
EndNote
HTML Citation
Reference Manager

 

Repository Staff Only: item control page

Metis ID: 201434