Distortion Cancellation by Polyphase Multipath Circuits

Share/Save/Bookmark

Mensink, E. and Klumperink, E.A.M. and Nauta, B. (2005) Distortion Cancellation by Polyphase Multipath Circuits. IEEE transactions on circuits and systems I: regular papers, 52 (9). pp. 1785-1794. ISSN 1549-8328

[img]PDF
Restricted to UT campus only
: Request a copy
442Kb
Abstract:t is well known that in balanced (or differential) circuits, all even harmonics are canceled. This cancellation is achieved by using two paths and exploiting phase differences of 180° between the paths. The question addressed in this paper is: what distortion products (harmonics and intermodulation products) are canceled if more than two paths (and phases) are used? These circuits are called polyphase multipath circuits. It turns out that the more paths (and phases) are used, the more distortion products are canceled. Unfortunately, some intermodulation products cannot be canceled without also canceling the desired signal. An analysis of the impact of mismatch between the paths shows that the suppression of distortion products will be larger if more paths are used. As an application example, the design of an upconversion mixer with a clean output spectrum is presented.
Item Type:Article
Copyright:© 2005 IEEE
Faculty:
Electrical Engineering, Mathematics and Computer Science (EEMCS)
Research Group:
Link to this item:http://purl.utwente.nl/publications/67680
Official URL:http://dx.doi.org/10.1109/TCSI.2005.852020
Export this item as:BibTeX
EndNote
HTML Citation
Reference Manager

 

Repository Staff Only: item control page

Metis ID: 224179