Formation of membranes by means of immersion precipitation : Part II. the mechanism of formation of membranes prepared from the system cellulose acetate-acetone-water

Share/Save/Bookmark

Reuvers, A.J. and Smolders, C.A. (1987) Formation of membranes by means of immersion precipitation : Part II. the mechanism of formation of membranes prepared from the system cellulose acetate-acetone-water. Journal of Membrane Science, 34 (1). pp. 67-86. ISSN 0376-7388

open access
[img]
Preview
PDF
1MB
Abstract:Using equations and boundary conditions derived in Part I1, calculations have been performed on the ternary diffusion processes that occur in a cellulose acetate (CA) -acetone casting solution immersed into a water bath. The necessary concentration-dependent thermodynamic and hydrodynamic parameters have been derived from experimental data on the three limiting binary mixtures. Calculations show that immersion of the polymer solution into the coagulation bath results in an instantaneous increase of the polymer concentration at the surface of the solution. For a CA-acetone casting solution the thickness of this concentrated surface layer will increase until the onset of liquid-liquid demixing by means of nucleation and growth of the diluted phase that fixes the asymmetric polymer distribution in the film. The moment of onset of the demixing process depends on the thickness of the film. However, addition of a certain minimum amount of water to the casting solution results in an instantaneous onset of liquid-liquid demixing upon immersion, yielding a membrane with a very thin skin layer. The model calculations have been confirmed by light transmission measurements performed on immersed casting solutions.
Item Type:Article
Copyright:© 1987 Elsevier Science
Research Group:
Link to this item:http://purl.utwente.nl/publications/67261
Official URL:http://dx.doi.org/10.1016/S0376-7388(00)80021-6
Export this item as:BibTeX
EndNote
HTML Citation
Reference Manager

 

Repository Staff Only: item control page