Fabrication of an electro-optic polymer microring resonator


Share/Save/Bookmark

Balakrishnan, M. and Klein, E.J. and Diemeer, M.B.J. and Driessen, A. and Faccini, M. and Verboom, W. and Reinhoudt, D.N. and Leinse, A. (2006) Fabrication of an electro-optic polymer microring resonator. In: IEEE/LEOS Benelux Chapter 2006 Annual Symposium, November 30 - December 1, 2006, Eindhoven, The Netherlands (pp. pp. 73-76).

open access
[img]
Preview
PDF
235kB
Abstract:A laterally coupled electro-optic polymer microring resonator was designed and fabricated. The design consists of microrings of 200 μm radius with racetrack structures to improve the coupling between the bus waveguide and the ring. Two different fabrication schemes namely reactive ion etching (RIE) and photodefinition are presented. Thermally grown siliconoxide on conducting silicon was used as the bottom cladding. Passive ring resonance behavior has been demonstrated around 1550 nm. The through port response of the ring showed a maximum extinction of about 12 dB and a finesse of 6.
Item Type:Conference or Workshop Item
Faculty:
Science and Technology (TNW)
Research Group:
Link to this item:http://purl.utwente.nl/publications/66827
Proceedings URL:http://www.photonics-benelux.org/index.php/leosb-documents/symposium-proceedings/2006
Organisation URL:http://www.photonics-benelux.org/
Export this item as:BibTeX
EndNote
HTML Citation
Reference Manager

 

Repository Staff Only: item control page

Metis ID: 237870