The BLIXER, a Wideband Balun-LNA-I/Q-Mixer Topology

Share/Save/Bookmark

Blaakmeer, Stephan C. and Klumperink, Eric A.M. and Leenaerts, Domine M.W. and Nauta, Bram (2008) The BLIXER, a Wideband Balun-LNA-I/Q-Mixer Topology. IEEE Journal of Solid-State Circuits, 43 (12). pp. 2706-2715. ISSN 0018-9200

[img]
Preview
PDF
1132Kb
Abstract:This paper proposes to merge an I/Q current-commutating mixer with a noise-canceling balun-LNA. To realize a high bandwidth, the real part of the impedance of all RF nodes is kept low, and the voltage gain is not created at RF but in baseband where capacitive loading is no problem. Thus a high RF bandwidth is achieved without using inductors for bandwidth extension. By using an I/Q mixer with 25% duty-cycle LO waveform the output IF currents have also 25% duty-cycle, causing 2 times smaller DC-voltage drop after IF filtering. This allows for a 2 times increase in the impedance level of the IF filter, rendering more voltage gain for the same supply headroom. The implemented balun-LNA-I/Q-mixer topology achieves > 18 dB conversion gain, a flat noise figure < 5.5 dB from 500 MHz to 7 GHz, IIP2 = +20 dBm and IIP3 = -3 dBm. The core circuit consumes only 16 mW from a 1.2 V supply voltage and occupies less than 0.01 mm2 in 65 nm CMOS.
Item Type:Article
Copyright:© 2008 IEEE
Faculty:
Electrical Engineering, Mathematics and Computer Science (EEMCS)
Research Group:
Link to this item:http://purl.utwente.nl/publications/65300
Official URL:http://dx.doi.org/10.1109/JSSC.2008.2004866
Export this item as:BibTeX
EndNote
HTML Citation
Reference Manager

 

Repository Staff Only: item control page

Metis ID: 255121