Modelling of bulk acoustic wave resonators for microwave filters


Share/Save/Bookmark

Jose, S. and Hueting, R.J.E. and Jansman, A.B.M. (2008) Modelling of bulk acoustic wave resonators for microwave filters. In: 11th Annual Workshop on Semiconductor Advances for Future Electronics and Sensors, SAFE 2008, 27-28 November 2008, Veldhoven, The Netherlands (pp. pp. 558-561).

open access
[img]
Preview
PDF
168kB
Abstract:Modelling and development of high Q thin-film bulk acoustic wave (BAW) devices is a topic of research gaining attention due to good selectivity and steep transition band offered by these devices used for cellular applications. A preliminary survey of various modeling approaches of these devices and their validations are presented in this paper. So far two existing one dimensional (1D) models have been investigated and compared. The results obtained from the models show relatively good agreement with experimental data of the FBAR reported in the literature. The prime objective of this project is to investigate novel BAW resonators, to determine the essential physical parameters and to develop physics based model thereof suited for circuit applications.
Item Type:Conference or Workshop Item
Faculty:
Electrical Engineering, Mathematics and Computer Science (EEMCS)
Research Group:
Link to this item:http://purl.utwente.nl/publications/65215
Export this item as:BibTeX
EndNote
HTML Citation
Reference Manager

 

Repository Staff Only: item control page

Metis ID: 255418