A Radiation hard bandgap reference circuit in a standard 0.13um CMOS Technology

Share/Save/Bookmark

Gromov, V. and Annema, A.-J. and Kluit, R. and Visschers, J.L. and Timmer, P. (2007) A Radiation hard bandgap reference circuit in a standard 0.13um CMOS Technology. IEEE transactions on nuclear science, 54 (6). pp. 2727-2733. ISSN 0018-9499

open access
[img]
Preview
PDF
906kB
Abstract:With ongoing CMOS evolution, the gate-oxide thickness steadily decreases, resulting in an increased radiation tolerance of MOS transistors. Combined with special layout techniques, this yields circuits with a high inherent robustness against X-rays and other ionizing radiation. In bandgap voltage references, the dominant radiation-susceptibility is then no longer associated with the MOS transistors, but is dominated by the diodes. This paper gives an analysis of radiation effects in both MOSdevices and diodes and presents a solution to realize a radiation-hard voltage reference circuit in a standard CMOS technology. A demonstrator circuit was implemented in a standard 0.13 m CMOS technology. Measurements show correct operation with supply voltages in the range from 1.4 V down to 0.85 V, a reference voltage of 405 mV 7.5 mV ( = 6mVchip-to-chip statistical spread), and a reference voltage shift of only 1.5 mV (around 0.8%) under irradiation up to 44 Mrad (Si).
Item Type:Article
Faculty:
Electrical Engineering, Mathematics and Computer Science (EEMCS)
Research Group:
Link to this item:http://purl.utwente.nl/publications/64563
Official URL:http://dx.doi.org/10.1109/TNS.2007.910170
Export this item as:BibTeX
EndNote
HTML Citation
Reference Manager

 

Repository Staff Only: item control page

Metis ID: 245903