Strain in Shear, and Material Behaviour in Incremental Forming

Share/Save/Bookmark

Emmens, W.C. and Boogaard, A.H. van den (2007) Strain in Shear, and Material Behaviour in Incremental Forming. In: Sheet Metal 2007, April 1-4, 2007, Palermo, Italy (pp. pp. 519-526).

open access
[img]
Preview
PDF
64kB
Abstract:This paper discusses some consequences of forming by shear, a situation that is sometimes claimed to occur in incremental forming. The determination of the principal strains and principal directions is discussed in detail. Two methods are presented: using a circular grid (although simulated on the computer), and by deriving formulae from the theory; both yield identical results. The strains assuming forming by shear are found to be (much) higher than in situations of forming by stretch. This affects notably more fundamental studies on material behaviour in incremental forming. The effects are illustrated using experimental data obtained with pre-stressed material.
Item Type:Conference or Workshop Item
Copyright:© 2007 Trans Tech Publications
Faculty:
Engineering Technology (CTW)
Research Chair:
Research Group:
Link to this item:http://purl.utwente.nl/publications/59683
Official URL:http://dx.doi.org/10.4028/www.scientific.net/KEM.344.519
Export this item as:BibTeX
EndNote
HTML Citation
Reference Manager

 

Repository Staff Only: item control page

Metis ID: 246138