Wrinkling in sheet metal forming: experimental testing vs. numerical analysis

Share/Save/Bookmark

Selman, A. and Atzema, E. and Meinders, T. and Boogaard van den, A.H. and Huetink, J. (2003) Wrinkling in sheet metal forming: experimental testing vs. numerical analysis. International journal of forming processes, 6 (2). pp. 147-160. ISSN 1292-7775

[img]PDF
Restricted to UT campus only
: Request a copy
1025Kb
Abstract:Following a number of publications on numerical prediction of wrinkling in thin sheet metal forming, the present part of our work is devoted to the comparison of numerical results with those obtained through experimental testing. A number of hemispherical product samples have been used with various blank holder forces and drawn to different depths to capture the onset of wrinkling, its mode and location
Item Type:Article
Copyright:Hermes Science Publications
Faculty:
Engineering Technology (CTW)
Research Chair:
Research Group:
Link to this item:http://purl.utwente.nl/publications/59429
Official URL:http://ijfp.revuesonline.com/
Export this item as:BibTeX
EndNote
HTML Citation
Reference Manager

 

Repository Staff Only: item control page