A material model for aluminium sheet forming at elevated temperatures

Boogaard van den, A.H. and Werkhoven, R.J. and Bolt, P.J. (2001) A material model for aluminium sheet forming at elevated temperatures. In: Fourth ESAFORM Conference on Material Forming, April 23-25, 2001, Liege, Belgium.

Preview

PDF
123Kb

Abstract:	In order to accurately simulate the deep drawing or stretching of aluminum sheet at elevated temperatures, a model is required that incorporates the temperature and strain-rate dependency of the material. In this paper two models are compared: a phenomenological material model in which the parameters of a Ludwik–Nadai hardening curve and a power law strain-rate influence are made temperature dependent and a physically-based model according to Bergstr¨om. The model incorporates the influence of the temperature on the flow stress and on the hardening rate and includes dynamic recovery aspects. Although both models can be fitted quite well to monotonic tensile tests, large differences appear if strain rate jumps are applied.
Item Type:	Conference or Workshop Item
Faculty:	Engineering Technology (CTW)
Research Chair:	Mechanics of Forming Technology (MFT)
Research Group:	Applied Mechanics (AM)
Link to this item:	http://purl.utwente.nl/publications/59390
Export this item as:	BibTeX EndNote HTML Citation Reference Manager

Show download statistics for this publication

Repository Staff Only: item control page