Effect of surface OH groups on catalytic performance of yittrium-stabilized ZrO2 in partial oxidation of CH4 to syngas

Share/Save/Bookmark

Zhu, Jianjun and Ommen, Jan G. van and Lefferts, Leon (2006) Effect of surface OH groups on catalytic performance of yittrium-stabilized ZrO2 in partial oxidation of CH4 to syngas. Catalysis Today, 117 (1-3). pp. 163-167. ISSN 0920-5861

[img] PDF
Restricted to UT campus only
: Request a copy
344kB
Abstract:The influence of water and surface hydroxyl groups on the catalytic performance of yittrium-stabilized ZrO2 (YSZ) in the partial oxidation of methane to synthesis gas was investigated using FT-IR as well as steady state kinetic experiments. Besides physically adsorbed water, terminal OH groups, bi-bridging and tri-bridging OH groups exist on the surface of YSZ. Oxidation of formaldehyde to formate occurs on the low index planes rather than at the structural defects, i.e. corners, edges, kinks and steps. Adsorbed formaldehyde is attacked by neighboring lattice oxygen ions in low index surface planes to form surface formate. Neighboring hydroxyl groups and hydrogen-bonded molecular water on the surface of YSZ suppress this nucleophilic attack.

In short, the presence of water on the surface stabilizes adsorbed formaldehyde, decreasing the rate of oxidation to formate; this effect is responsible for the increase in selectivity to H2 and CO when water is added during CPO.
Item Type:Article
Copyright:© 2006 Elsevier
Faculty:
Science and Technology (TNW)
Research Group:
Link to this item:http://purl.utwente.nl/publications/57953
Official URL:http://dx.doi.org/10.1016/j.cattod.2006.05.046
Export this item as:BibTeX
EndNote
HTML Citation
Reference Manager

 

Repository Staff Only: item control page