Analysis of Material Transfer From a Soft Workpiece to a Hard Tool: Part II-Experimental Verification of the Proposed Lump Growth Model

Share/Save/Bookmark

Rooij de, M.B. and Schipper, D.J. (2001) Analysis of Material Transfer From a Soft Workpiece to a Hard Tool: Part II-Experimental Verification of the Proposed Lump Growth Model. Journal of Tribology, 123 (3). pp. 474-478. ISSN 0742-4787

[img]
Preview
PDF
374Kb
Abstract:In this study, the lump growth model, described in an accompanying paper (de Rooij and Schipper, 2000) is validated by means of experiments performed on a deepdrawing simulator. In the experiments, the influence of material and roughness properties of both sheet and tool on the galling behavior is determined. For these experiments, a deepdrawing simulator and a selection of aluminum and zinc coated sheets with several (coated) deepdrawing tools are used. Good agreement is found between results of the lump growth model and the sheet metal forming experiments.
Item Type:Article
Copyright:© 2001 ASME
Faculty:
Engineering Technology (CTW)
Research Group:
Link to this item:http://purl.utwente.nl/publications/57187
Official URL:http://dx.doi.org/10.1115/1.1308023
Export this item as:BibTeX
EndNote
HTML Citation
Reference Manager

 

Repository Staff Only: item control page

Metis ID: 203417