Gas foaming of segmented poly(ester amide) films

Share/Save/Bookmark

Lips, P.A.M. and Velthoen, I.W. and Dijkstra, P.J. and Wessling, M. and Feijen, J. (2005) Gas foaming of segmented poly(ester amide) films. Polymer, 46 (22). pp. 9396-9403. ISSN 0032-3861

[img] PDF
Restricted to UT campus only
: Request a copy
453kB
Abstract:Biodegradable segmented poly(ester amide)s, based on dimethyl adipate, 1,4-butanediol and N,N¿-1,2-ethanediyl-bis[6-hydroxy-hexanamide], with two distinct melting transitions were gas foamed using carbon dioxide (CO2). Polymer films were saturated with CO2 at 50 bar for 6 h after which the pressure was released. The samples were immersed in octane at the desired temperature after which foaming started immediately. Just above the lower melt transition the polymers retain adequate mechanical properties and dimensional stability, while the chain mobility increased sufficiently to nucleate and expand gas cells during the foaming process. In this way semi-crystalline poly(ester amide)s can be gas foamed below the flow temperature.

Two poly(ester amide)s with 25 mol% (PEA2,5-25) and 50 mol% (PEA2,5-50) of bisamide segment content were foamed at 70 and 105 °C, respectively. The storage modulus (G¿) of both pure polymers at the onset foaming temperature is 50¿60 MPa. Closed-cell foams were obtained with a maximum porosity of not, vert, similar90%. The average pore size of PEA2,5-25 ranges from 77 to 99 ¿m. In contrast, the average pore size of PEA2,5-50 is in between 2 and 4 ¿m and can be increased to 100 ¿m by lowering the CO2 saturation pressure to 20 bar. The porosity of PEA2,5-50 foams using this saturation pressure decreased to 70%
Item Type:Article
Copyright:© 2005 Elsevier Ltd
Faculty:
Science and Technology (TNW)
Research Group:
Link to this item:http://purl.utwente.nl/publications/54815
Official URL:http://dx.doi.org/10.1016/j.polymer.2005.07.052
Export this item as:BibTeX
EndNote
HTML Citation
Reference Manager

 

Repository Staff Only: item control page

Metis ID: 229350