Performance of an ITER CS1 Model Coil Conductor under T ransverse Cyclic Loading up to 40,000 cycles


Nijhuis, A. and Ilyin, Yu. and Abbas, W. and Haken, B. ten and Kate, H.H.J. ten (2004) Performance of an ITER CS1 Model Coil Conductor under T ransverse Cyclic Loading up to 40,000 cycles. IEEE Transactions on Applied Superconductivity, 14 (2). pp. 1489-1494. ISSN 1051-8223

open access
Abstract:The large currents in the cable-in-conduit conductors (CICC) destined for the high field magnets in the International Thermonuclear Experimental Reactor (ITER), cause huge transverse forces on the strands compressing the cable against one side of the conduit. This load causes transverse compressive strain in the strands at the crossovers contacts. Moreover, the strands are also subjected to bending and contact surfaces micro-sliding, which results into friction and anomalous contact resistance versus force behavior. Three Nb/sub 3/Sn central solenoid model coil (CSMC) conductors were tested previously in the Twente Cryogenic Cable Press up to 40 cycles with a transverse peak load of 650 kN/m. This press can transmit a variable (cyclic) transverse force directly to a cable section of 400 mm length at a temperature of 4.2 K (or higher). To explore life-time cycling, we tested a CSMC Nb/sub 3/Sn conductor up to 40,000 cycles. The coupling loss and the associated interstrand resistance between various strands and strand bundles are measured at various loads. The force on the cable and the displacement are monitored in order to determine the effective cable Young's modulus and the mechanical heat generation. Some aspects of strand deformation in CICC's are discussed. The test results are discussed in view of previous press results and data extracted from the ITER model coil tests.
Item Type:Article
Copyright:©2004 IEEE
Science and Technology (TNW)
Research Group:
Link to this item:
Official URL:
Export this item as:BibTeX
HTML Citation
Reference Manager


Repository Staff Only: item control page

Metis ID: 223048