Phase correction for Learning Feedforward Control

Kruif de, Bas J. and Vries de, Theo J.A. (2003) Phase correction for Learning Feedforward Control. In: IEEE/ASME International Conference on Advanced Intelligent Mechatronics, AIM 2003, 20-24 July 2003, Kobe, Japan.

Preview

PDF
438Kb

Abstract:	Intelligent mechatronics makes it possible to compensate for effects that are difficult to compensate for by construction or by linear control, by including some intelligence into the system. The compensation of state dependent effects, e.g. friction, cogging and mass deviation, can be realised by learning feedforward control. This method identifies these disturbing effects as function of their states and compensates for these, before they introduce an error. Because the effects are learnt as function of their states, this method can be used for non-repetitive motions. The learning of state dependent effects relies on the update signal that is used. In previous work, the feedback control signal was used as an error measure between the approximation and the true state dependent effect. If the effects introduce a signal that contains frequencies near the bandwidth, the phase shift between this signal and the feedback signal might seriously degenerate the performance of the approximation. The use of phase correction overcomes this problem. This is validated by a set of simulations and experiments that show the necessity of the phase corrected scheme.
Item Type:	Conference or Workshop Item
Copyright:	©2003 IEEE
Faculty:	Electrical Engineering, Mathematics and Computer Science (EEMCS)
Research Group:	Robotics and Mechatronics (CE)
Link to this item:	http://purl.utwente.nl/publications/45436
Official URL:	http://dx.doi.org/10.1109/AIM.2003.1225170
Export this item as:	BibTeX EndNote HTML Citation Reference Manager

Show download statistics for this publication

Repository Staff Only: item control page

Metis ID: 212285