Design and fabrication of a hydrodynamic chromatography chip

Share/Save/Bookmark

Blom, M.T. and Chmela, E. and Gardeniers, J.G.E. and Tijssen, R. and Elwenspoek, M. and Berg van den, A. (2002) Design and fabrication of a hydrodynamic chromatography chip. Sensors and Actuators B: Chemical, 82 (1). pp. 111-116. ISSN 0925-4005

[img]PDF
Restricted to UT campus only
: Request a copy
213Kb
Abstract:A chromatography chip is presented in which the analysis is performed by polymer separation entirely based on geometry. Design and fabrication are discussed for a chip incorporating an injection structure and a separation channel. The injection is characterized by fluorescence measurements. Chromatographic performance was shown by separation of fluorescein and 26 nm fluorescent particles.
Item Type:Article
Copyright:© 2002 Elsevier Science B.V.
Faculty:
Science and Technology (TNW)
Electrical Engineering, Mathematics and Computer Science (EEMCS)
Research Group:
Link to this item:http://purl.utwente.nl/publications/43026
Official URL:http://dx.doi.org/10.1016/S0925-4005(01)00989-3
Export this item as:BibTeX
EndNote
HTML Citation
Reference Manager

 

Repository Staff Only: item control page

Metis ID: 205436