A computer aided tolerancing tool, I: tolerancing specification

Share/Save/Bookmark

Salomons, O.W. and Jonge Poerink, H.J. and Haalboom, F.J. and Slooten, F. van and Houten, F.J.A.M. van and Kals, H.J.J. (1996) A computer aided tolerancing tool, I: tolerancing specification. Computers in Industry, 31 (2). pp. 161-174. ISSN 0166-3615

open access
[img]
Preview
PDF
1MB
Abstract: current tolerancing practice, designers have to manually specify tolerances: either on a drawing or in a CAD system. Different designers will possibly arrive at different tolerance specifications for the same nominal geometry. The paper demonstrates that this situation can be avoided in the case of functional tolerancing with a focus on the geometry relevant for functioning. Under this restriction, the specification of too tight or too many tolerances can also be avoided. The paper describes a tool for functional tolerance specification which supports the user in automatically proposing geometric tolerance types where the user only has to give in the tolerance values. Apart from this semi-automatic tolerance type specification, manual specification is still possible.
Item Type:Article
Copyright:© 1996 Elsevier Science
Faculty:
Engineering Technology (CTW)
Research Group:
Link to this item:http://purl.utwente.nl/publications/32232
Official URL:http://dx.doi.org/10.1016/0166-3615(96)00046-2
Export this item as:BibTeX
EndNote
HTML Citation
Reference Manager

 

Repository Staff Only: item control page

Metis ID: 144483