Novel supplies for powering a sueprconducting magnet

Share/Save/Bookmark

Shevchenko, O.A. and Krooshoop, H.J.G. and Kate, H.H.J. ten and Grunblatt, G. and Shevchenko, A.A. and Kolesnitchenko, A.F. and Sidorenko, V.D. and Grytsina, A.E. and Lysenko, V. and Scherbakov, V.I. and Anashkin, O. and Keylin, V.E. (2000) Novel supplies for powering a sueprconducting magnet. IEEE Transactions on Applied Superconductivity, 10 (1). pp. 1414-1417. ISSN 1051-8223

open access
[img]
Preview
PDF
371kB
Abstract:A family of new supplies for powering superconducting magnets was developed in our institutes. As an example, two supplies are described in the paper. One of the supplies uses superconducting, another-semiconductor-based repetitive switches. Both supplies are able to generate 1 Volt at the high-current side. Magnets to be powered by the supplies are made with Nb3Sn and NbTi wires, operate at 600 and 300 Amps, have inductances of 1.2 and 1.3 Henry and generate magnetic fields of 12 and 7 Tesla, respectively. Both magnets operate art 4 Kelvin and are bath-cooled. So far the power supplies were tested at the operating temperature using a small sc magnet as a load. Expected load curves, while ramping the current of the real magnets, are also discussed. A comparison between these sc supplies and a conventional system based on a room temperature power supply with (high-Tc) current leads is made
Item Type:Article
Copyright:©2000 IEEE
Faculty:
Science and Technology (TNW)
Research Group:
Link to this item:http://purl.utwente.nl/publications/23900
Official URL:http://dx.doi.org/10.1109/77.828504
Export this item as:BibTeX
EndNote
HTML Citation
Reference Manager

 

Repository Staff Only: item control page

Metis ID: 128699