Design and fabrication of a HTc quasi-one junction SQUID based comparator for a 4-bit superconductive flash A/D converter

Reuvekamp, E.M.C.M. and Booi, P.A.A. and Verhoeven, M.A.J. and Gerritsma, G.J. and Rogalla, H. (1993) Design and fabrication of a HTc quasi-one junction SQUID based comparator for a 4-bit superconductive flash A/D converter. IEEE Transactions on Applied Superconductivity, 3 (1, Par). pp. 2621-2624. ISSN 1051-8223

Preview

PDF
624Kb

Abstract:	The design of a quasi-one-junction superconducting quantum interference device (SQUID)-based comparator for an all HTC superconductive 4-b flash analog-to-digital (A/D) converter is proposed and discussed. Ramp-type junctions of YBCO/PBCO/YBCO are used. The inductance can be realized by a stripline between the junctions. Simulations by the PSCAN package show correct behavior of the quasi-one-junction SQUID (QOS) up to frequencies of approximately 1 GHz. The output voltage pulses are periodic with the input current, as expected. In the dynamic simulations, output voltage pulses are observed at an applied flux of around (2m-1)¿0/2. Tile junctions in the QOS are structured on two ramp-edges. The operating frequencies will be below 1 MHz in this first design. A first realization uses the YBa2Cu3O7-x (YBCO) superconductor and PrBa2Cu3O7-x (PBCO) as junction barrier and electrode interlayer material. On a 10-mm×10-mm SrTiO3 (001) substrate, nine comparators and four separate ramp-edge junctions are realized
Item Type:	Article
Copyright:	©1993 IEEE
Faculty:	Science and Technology (TNW)
Research Group:	Low Temperatures - Biomagnetism (LT)
Link to this item:	http://purl.utwente.nl/publications/23743
Official URL:	http://dx.doi.org/10.1109/77.233519
Export this item as:	BibTeX EndNote HTML Citation Reference Manager

Show download statistics for this publication

Repository Staff Only: item control page

Metis ID: 128542