An electrochemical active valve

Share/Save/Bookmark

Neagu, C.R. and Gardeniers, J.G.E. and Elwenspoek, M. and Kelly, J.J. (1997) An electrochemical active valve. Electrochimica Acta, 42 (20-22). pp. 3367-3373. ISSN 0013-4686

open access
[img]
Preview
PDF
595kB
Abstract:A novel electrochemical microactuator was developed, which operates as an active valve. The microactuator consists of an electrochemical cell and a membrane that deflects because of the pressure of oxygen gas generated by electrolysis. Relatively large pressures (up to tens of bars) can be reached with only low energy consumption (in the μW range). In a first prototype a Cu/aq. 1 M CuSO4/Pt system was used in an electrochemical cell with dimensions 2×2×1 mm3, fabricated with silicon micromachining and thin film deposition techniques. When the actuator was driven at 1.6 V and currents below 50 μA, pressures of 2 bar could be obtained within seconds, causing membrane deflections in the 30 to 70 μm range. It was found that, in order to improve the performance of the microactuator, it will be necessary to replace the Cu/Cu2+ electrode. A possible alternative is the Sb/Sb-oxide electrode. This system was studied cyclic voltammetry and the first results are promising.
Item Type:Article
Copyright:© 1997 Elsevier Science Ltd.
Faculty:
Science and Technology (TNW)
Electrical Engineering, Mathematics and Computer Science (EEMCS)
Research Group:
Link to this item:http://purl.utwente.nl/publications/14243
Official URL:http://dx.doi.org/10.1016/S0013-4686(97)00189-8
Export this item as:BibTeX
EndNote
HTML Citation
Reference Manager

 

Repository Staff Only: item control page

Metis ID: 111508