The preparation and characterization of Y-TZP/20 wt% alumina

Share/Save/Bookmark

Exter, P. den and Winnubst, A.J.A. and Burggraaf, A.J. (1993) The preparation and characterization of Y-TZP/20 wt% alumina. Journal of the European Ceramic Society, 11 (6). pp. 497-507. ISSN 0955-2219

open access
[img]
Preview
PDF
1MB
Abstract:Zirconia (+2-2·5 mol% yttria)/12-20 wt% alumina composite powders have been prepared by several techniques. The preparation methods were discussed in terms of powder characteristics, densification behaviour and microstructure. The densification behaviour of the composites depended on the crystal structure of the phases and on the dispersion of the alumina in the Y-TZP matrix. Both the spraying and coprecipitation methods resulted in an inhomogeneous dispersion and a relatively low density (95%), caused by either differential sintering of alumina aggregates (coprecipitation method) or by an inhomogeneous dispersion of the alumina (spraying method). Both the acetyl acetonate and the (alpha)-alumina methods resulted in high density (98%) ceramics in which the alumina was homogeneously dispersed. The (alpha)-alumina method, however, required higher sintering temperatures (1450°C) than the acetyl acetonate method. Both methods gave better results than those obtained with a commercially available powder.
Item Type:Article
Copyright:© 1993 Elsevier Science
Faculty:
Science and Technology (TNW)
Research Group:
Link to this item:http://purl.utwente.nl/publications/12679
Official URL:http://dx.doi.org/10.1016/0955-2219(93)90109-5
Export this item as:BibTeX
EndNote
HTML Citation
Reference Manager

 

Repository Staff Only: item control page

Metis ID: 106860