Dispersion behaviour of solid particles in flow-injection analysis

Share/Save/Bookmark

Hulsman, M.H.F.M. and Bos, M. and Linden van der, W.E. (1997) Dispersion behaviour of solid particles in flow-injection analysis. Analytica Chimica Acta, 346 (3). pp. 351-360. ISSN 0003-2670

[img]
Preview
PDF
668Kb
Abstract:In order to achieve a reproducible on-line pretreatment of slurry samples in flow-injection analysis the dispersion behaviour of these samples has to be examined. This paper reports the effects of flow rate and some configurations of reaction manifolds. The reaction manifolds were a straight tube and two helically coiled tubes with different aspect ratios and spatial orientation. The slurry samples consisted of spheres of different densities suspended in a Triton X-100/water solution, the particle diameters (up to 75 ¿m) were relatively large compared to the internal diameter of the tubing (0.75 mm). For the straight tube theoretical calculations were found to give a reasonable impression of the experimental flow behaviour of the spheres. Statistical moments were used to characterize the slurry peaks. For tightly coiled tubes it was found that the retention time of a slurry sample depends on the particle density. The spatial orientation of the coils mainly affects the retention of high density particles.
Item Type:Article
Copyright:© 1997 Elsevier Science
Research Group:
Link to this item:http://purl.utwente.nl/publications/12495
Official URL:http://dx.doi.org/10.1016/S0003-2670(97)90077-5
Export this item as:BibTeX
EndNote
HTML Citation
Reference Manager

 

Repository Staff Only: item control page

Metis ID: 106692