Oxidative coupling of methane in a mixed-conducting perovskite membrane reactor

Share/Save/Bookmark

Elshof, J.E. ten and Bouwmeester, H.J.M. and Verweij, H. (1995) Oxidative coupling of methane in a mixed-conducting perovskite membrane reactor. Applied Catalysis A: General, 130 (2). pp. 195-212. ISSN 0926-860X

open access
[img]
Preview
PDF
1MB
Abstract:Ionic-electronic mixed-conducting perovskite-type oxide La0.6Sr0.4Co0.8Fe0.2O3 was applied as a dense membrane for oxygen supply in a reactor for methane coupling. The oxygen permeation properties were studied in the pO2-range of 10¿3¿1 bar at 1073¿1273 K, using helium as a sweeping gas at the permeate side of the membrane. The oxygen semi-permeability has a value close to 1 mmol m¿2 s¿1 at 1173 K with a corresponding activation energy of 130¿140 kJ/mol. The oxygen flux is limited by a surface process at the permeate side of the membrane. It was found that the oxygen flux is only slightly enhanced if methane is admixed with helium. Methane is converted to ethane and ethene with selectivities up to 70%, albeit that conversions are low, typically 1¿3% at 1073¿1173 K. When oxygen was admixed with methane rather than supplied through the membrane, selectivities obtained were found to be in the range 30¿35%. Segregation of strontium was found at both sides of the membrane, being seriously affected by the presence of an oxygen pressure gradient across it. The importance of a surface limited oxygen flux for application of perovskite membranes for methane coupling is emphasized.
Item Type:Article
Copyright:© 1995 Elsevier Science
Faculty:
Science and Technology (TNW)
Research Group:
Link to this item:http://purl.utwente.nl/publications/12024
Official URL:http://dx.doi.org/10.1016/0926-860X(95)00098-4
Export this item as:BibTeX
EndNote
HTML Citation
Reference Manager

 

Repository Staff Only: item control page

Metis ID: 106456