A small scale regularly packed circulating fluidized bed. Part I: Hydrodynamics.

Share/Save/Bookmark

Ham, A.G.J. van der and Prins, W. and Swaaij, W.P.M. van (1994) A small scale regularly packed circulating fluidized bed. Part I: Hydrodynamics. Powder Technology, 79 (1). pp. 17-28. ISSN 0032-5910

open access
[img]
Preview
PDF
1MB
Abstract:The present investigation is based on the idea of intensifying the gas¿solids contact in a circulating fluidized bed by introducing obstacles into it. Such obstacles may effectively suppress radial inhomogeneities in the solids flux and concentration, increase the dynamic solids hold-up, and break up solids clusters. This article (Part I) deals with the hydrodynamics (pressure drop and solids hold-up) investigated at ambient conditions, for cocurrent upward flow of air and microsize solid particles (FCC, 70 µm diameter) over a regularly structured inert packing introduced into the riser part of a circulating fluidized bed unit. The packed section has a height of 0.48 m, a cross-sectional area of 0.06 × 0.06 m2 and contains regularly-stacked 0.01 m diameter Perspex bars as the obstacles meant to enhance the gas¿solids contact. Slide-valves mounted above and below the packed section can be used to trap the solids inventory and determine the (dynamic) solids hold-up. Gas and solids mass fluxes have been varied in the range of 0.7 < Gg < 4.4 and O < Gs < 15 kg m-2s-2, respectively. Part II will report on the results of gas¿solids mass transfer measurements, which have been carried out in the same set-up at comparable experimental conditions. Results of this work show that: (i) the pressure gradient over the packed section increases linearly with increasing solids mass flux, but faster than linearly with increasing applied gas mass flux, (ii) the dynamic solids volume fraction can be described quite well by the correlation ß dyn = 0.0084 GsGg-1.22 for almost the entire range of applied gas and solids mass fluxes, (iii) the value for the solids friction factor derived for the gas flux range 0.7 < Gg < 3.7 kg (m-2s-1) varies from 1.4 to 2.5 and is linear with the solids volume fraction. These fs values are about 2 to 3 decades higher than those obtained from fs correlations derived for dilute-phase pneumatic conveying lines operated under the same experimental conditions.
Item Type:Article
Copyright:© 1994 Elsevier Science
Faculty:
Science and Technology (TNW)
Research Group:
Link to this item:http://purl.utwente.nl/publications/11179
Official URL:http://dx.doi.org/10.1016/0032-5910(93)02805-K
Export this item as:BibTeX
EndNote
HTML Citation
Reference Manager

 

Repository Staff Only: item control page

Metis ID: 106033